Drawings/part#

Everything about your Aeronca, not Chief or Champ or Sedan specific.
Post Reply
roady0309
Posts: 17
Joined: Mon Nov 20, 2017 06:34
Location: Eufaula, Alabama
Contact:

Drawings/part#

Post by roady0309 » Sun Feb 11, 2018 13:21

Hello I have a 65-CA Me and my IA are looking for the drawing number or part number for the Bolt or in my case stud where the horizontal tail fins are connected to the fuselage. We are curious about this connection and the type of nuts used. Any help would be appreciated.
Thanks
N36522

Paul Agaliotis
Posts: 2461
Joined: Wed Dec 08, 2004 18:49
Location: San Martin, California
Contact:

Re: Drawings/part#

Post by Paul Agaliotis » Sun Feb 11, 2018 22:45

I've seen a few variations of this connection. One was a long internal wrenching bolt, one was a long clevis pin. The last which I think is correct is a long stud, threaded on both ends with a barrel style nut on each end with cotter pins securing the nuts to the stud.
Paul
Mailing Adress : Paul Agaliotis 2060 E. San Martin, San Martin,Calif. 95046

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest