National Aeronca Association Bulletin Board

A discussion group for all Aeronca owners and fans
It is currently Sun May 28, 2017 07:34

All times are UTC - 7 hours




Post new topic Reply to topic  [ 48 posts ]  Go to page Previous  1, 2, 3, 4
Author Message
PostPosted: Sun Mar 03, 2013 01:12 
Offline
User avatar

Joined: Sun Mar 27, 2005 07:57
Posts: 313
Location: Switzerland
Thanks Nathan!

Looks like this is a safe, simple and fast method. In our case the challenge might be finding a hole saw of the correct diameter for the Sedan inspection cover kit.

Matt

_________________
Aeronca 15AC Sedan – Restoring and flying the classic 4-seater: http://www.n1331h.com


Top
 Profile  
 
PostPosted: Sun Mar 03, 2013 08:00 
Offline

Joined: Sat Oct 29, 2011 07:42
Posts: 121
Location: Indian Hills Airpark Salome, AZ
I've installed any number of Ercoupe center section inspection openings using a large hole saw. Done carefully it works like a charm.

Paul
2AZ1


Top
 Profile  
 
PostPosted: Mon Jun 10, 2013 11:02 
Offline
Site Admin
User avatar

Joined: Thu Nov 11, 2004 11:01
Posts: 6033
Location: Phoenix Arizona
Boy guys!

Just cut holes in one wing with another Sedan here in town and I have to say that Brian Safran's tool (believe Mike Hoag and JC helped make it) works like a charm! Whoever made this sure deserves drinks at Middletown 2014!

We ended up doing 5 inspection cover holes in one wing and will probably do the same in the other wing. We can now see and access any part of the wing needed for any inspection. Found some very light surface corrosion on one part but thats all. It came right off with scotchbrite and now has been treated with ACF50, so thats taken care of.

It worked very well and after we got used to doing them could make two holes in 30 minutes. The learning curve is pretty good but once you have done 1-2 of them and are comfortable with it the process is easy.

Only issue is that you have to have a good air supply. We finally hooked his small compressor up to a "piggy" (big aux air tank that acted as a reserve supply) and once we had that going all was well.

We should be finished with this one later on this week and will be sending the tool along to the next person in line. I am going to include new drill bits and so on as these are getting a bit worn and this will help the next guys in line.

Joe A


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 48 posts ]  Go to page Previous  1, 2, 3, 4

All times are UTC - 7 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
POWERED_BY
Translated by Maël Soucaze © 2009 phpBB.fr